Weider Pro 250x English Manual - Page 6

ASSEMBLY Make Things Easier for Yourself This manual is designed to ensure that the weight bench can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • Assembly requires two people. • For help identifying small parts, use the PART IDENTIFICATION CHART on page 5. • Tighten all parts as you assemble them, unless instructed to do otherwise. • As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. The following tools (not included) are required for assembly: • Two adjustable wrenches • One rubber mallet • One standard screwdriver • One Phillips screwdriver • Lubricant, such as grease or petroleum jelly, and soapy water. Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. 1. Before beginning assembly, be sure that you have read and understand the information in the box above. Press a 50mm x 70mm Inner Cap (46) into the end of the Left Base (2). Attach three Rubber Pads (37) to the bottom of the Left Base with three M4 x 16mm Self-tapping Screws (42) and three M4 Washers (49). Repeat this step with the Right Base (3). 2. Press a 50mm x 100mm Inner Cap (44) into the top of the Center Upright (4). Press two 50mm Square Inner Caps (47) into the base on the Center Upright. Attach a Rubber Pad (37) to the bottom of the Center Upright (4) with an M4 x 16mm Self-tapping Screw (42) and an M4 Washer (49). 1 46 37 49 42 2 37 49 42 2 44 37 49 42 4 47 37 47 42 49 6