Weider Pro 250x English Manual - Page 7
Tighten the M8 Nylon Locknuts 33 used
View all Weider Pro 250x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Attach the Left and Right Bases (2, 3) to the 3 Center Base (4) with four M8 x 67mm Bolts (27) and four M8 Nylon Locknuts (33). Do not tighten the Locknuts yet. 2 3 4 33 33 4. Press a 50mm x 70mm Inner Cap (46) into the 4 top of a Weight Rack (5). Press a 25.4mm Round Inner Cap (29) into the end of the tube on the Weight Rack. Repeat this step with the other Weight Rack (5). 27 27 46 29 5 5. Orient the Floor Base (1) as shown. Set the 5 bracket on a Weight Rack (5) over the indicated holes in the Left Base (2). Attach the Weight Rack and the Floor Base to the Left Base with two M8 5 Bracket x 67mm Bolts (27) and two M8 Nylon Locknuts 3 (33). Be sure the Floor Base is attached out- side of the bracket on the Weight Rack. 33 Attach the other Weight Rack (5) to the Right 27 Base (3) in the same manner. 1 Tighten the M8 Nylon Locknuts (33) used in 2 step 3. 6. Identify the Left Upright (6) by the position of the 6 bracket at the bottom. Orient the Left Upright so that the latch is on the side shown. Attach the Left Upright (6) to the Left Base (2) with two M8 x 67mm Bolts (27), a Support Plate (38), and two M8 Nylon Locknuts (33). Attach the Right Upright (not shown) to the Right Base (3) in the same manner. 2 3 Latch 6 33 Bracket 27 38 7