Weider Pro 3200 English Manual - Page 16
Locate the Low Cable 47.
View all Weider Pro 3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
37. Attach the end of the Leg Lever Cable (96) to the 37 other "U"-Bracket (85) with an M8 Washer (26) and an M8 Nylon Locknut (71). Note: Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset draw- ing. 38. Locate the Low Cable (47). Route the small ball 38 on the Cable through the cage on the Leg Press Frame (30). Attach a 90mm Pulley (38) inside the Leg Press Frame (30) with an M10 x 70mm Bolt (81), two M10 Washers (75), two 13mm Spacers (34), and an M10 Nylon Locknut (70). 96 26 71 85 96 71 38 34 81 75 30 34 70 75 Cage 47 39. Route the Low Cable (47) through the Left Leg (36) and the Left Upright (7). Attach a 90mm Pulley (38) inside the Upright with an M10 x 70mm Bolt (81), two M10 Washers (75), two 13mm Spacers (34), and an M10 Nylon Locknut (70). 39 34 38 75 70 34 75 81 7 47 36 40. Wrap the Low Cable (47) around a 90mm Pulley 40 (38). Attach the Pulley and a Cable Trap (91) to the lower set of holes in the indicated "U"-Bracket (85) with an M10 x 50mm Bolt (62) and an M10 Nylon Locknut (70). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley. 85 62 70 91 38 47 16