Weider Pro 3200 English Manual - Page 19

SEAT ASSEMBLY 49. Press two 20mm x 40mm Inner Caps (104) and a 25mm x 40mm Inner Cap (105) into an Adjustable Seat Frame (100). Attach a Seat (16) to an Adjustable Seat Frame (100) with two M6 x 16mm Screws (13), an M6 x 33mm Screw (90), and an M6 Washer (35). Insert the Adjustable Seat Frame (100) into the Right Seat Frame (5) and secure it with an Adjustment Knob (102). Repeat this step with the other Seat (16) and the Left Seat Frame (not shown). 50. Press two 20mm x 40mm Inner Caps (104) and a 25mm x 40mm Inner Cap (105) into the Adjustable Backrest Frame (101). Attach a Backrest (15) to the Adjustable Backrest Frame (101) with four M6 x 16mm Bolts (13). Insert the Adjustable Backrest Frame (101) into the Right Upright (6) and secure it with an Adjustment Knob (102). Attach the other Backrest (15) and the Left Upright (not shown) with four M6 x 16mm Bolts (13). 51. Slide the Long Pad Tube (17) through the hole in the Right Leg (73). Slide two Foam Pads (18) onto the ends of the Pad Tube. Press two 19mm Round Inner Caps (27) into the ends of the Pad Tube. Repeat this step with the Short Pad Tube (94) and the Leg Lever (4). 52. Press a 50mm x 70mm Inner Cap (22) into the indicated end of the Adjustment Tube (88). Attach the Leg Press Plate (31) to the Adjustment Tube (88) with an M8 x 65mm Bolt (89), two M8 Washers (26), and an M8 Nylon Locknut (71). Attach the Adjustment Tube (88) to the Leg Press Frame (30) with the Leg Press Pin (87). Be sure the Pin is in the locked position around the Leg Press Frame. 49 16 104 100 104 13 35 105 90 5 102 50 104 6 101 13 15 51 18 27 17 4 94 52 87 13 105 102 104 18 27 73 22 88 26 71 26 30 89 31 19