Weider Pro 3200 English Manual - Page 18

45. Wrap the Low Cable (47) around a 90mm Pulley 45 (38). Attach the Pulley and a Cable Trap (91) to the indicated bracket on the Right Base (1) with an M10 x 45mm Bolt (66) and an M10 Nylon Locknut (70). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley. 70 91 38 46. Wrap the Low Cable (47) around a 90mm Pulley 46 (38). Attach the Pulley and a Cable Trap (91) to the lower set of holes in the indicated "U"-Bracket (85) with an M10 x 50mm Bolt (62) and an M10 Nylon Locknut (70). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley. 1 66 70 91 38 85 62 47 47. Wrap the Low Cable (47) around a 90mm Pulley (38). Attach the Pulley and a Cable Trap (91) to the side of the Right Upright (6) with an M10 x 95mm Bolt (98), an M10 Washer (75), and an M10 Nylon Locknut (70). Be sure the Cable Trap is turned to hold the Cable in the groove of the Pulley. 47 98 47 91 38 6 75 70 48. Wrap the Low Cable (47) around a 90mm Pulley 48 (38). Attach the Pulley and a pair of Pulley Small Covers (92) to the Right Upright (6) with an M10 x 100mm Bolt (84), two M10 Washers (75), and an M10 Nylon Locknut (70). Be sure the small Tabs 75 84 tabs on the Pulley Covers are on the side shown, and the Cable is between the Pulley and the rod on the Upright. 92 38 47 92 6 75 70 18