Weider Pro 3650 English Manual - Page 13
M10 x 50mm Bolt 100 and an M10 Nylon Locknut
View all Weider Pro 3650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
24. Remove the preattached 90mm Pulleys (78) from the Offset Double "U"-bracket (61). 24 Wrap the Swivel Cable (17) around a 90mm Pulley (78). Attach the Pulley to the Offset Double "U"bracket (61) with an M10 x 45mm Bolt (93) and an M10 Nylon Locknut (87). 25. Wrap the Swivel Cable (17) around a 90mm Pulley 25 (78). Attach the Pulley and a Cable Trap (68) to the next to bottom hole in the Small Pulley Plates (31) with an M10 x 50mm Bolt (100) and an M10 Nylon Locknut (87). Make sure the Cable Trap is turned to hold the Cable in the groove of the Pulley. 17 78 93 61 87 31 87 100 78 17 68 26. Wrap the Swivel Cable (17) around a 90mm Pulley (78). Attach the Pulley and a Long Cable Trap (102) to the bracket on the Swivel Upright (5) with an M10 x 50mm Bolt (100) and an M10 Nylon Locknut (87). Make sure the Cable Trap is turned to hold the Cable in the groove of the Pulley. 27. Attach the end of the Swivel Cable (17) to the bracket on the Swivel Carriage (46) with an M10 x 20mm Bolt (86) and an M10 Nylon Locknut (87). 26 5 102 87 27 46 87 100 17 78 86 17 28. Locate the Lat Cable (88), which is 2263mm long and has a ball on one end and an eyelet on the other. Route the eyelet end of the Cable up through the Butterfly Top Frame (7) and around a 90mm Pulley (78). Attach the Pulley inside of the Butterfly Top Frame with an M10 x 65mm Bolt (101), two M10 Washers (91), two 12mm Spacers (89), and an M10 Nylon Locknut (87). 28 78 87 91 89 7 88 89 91 18 13