Weider Pro 3650 English Manual - Page 20

57. Press two 20mm x 40mm Inner Caps (116) and a 57 25mm x 40mm Square Inner Cap (117) into the Seat Bracket (11). Attach the Seat (16) to the Seat Bracket (11) with two M6 x 16mm Screws (114), an M6 x 35mm Screw (99), and an M6 Washer (97). Turn the indicated Adjustment Handle (65) counterclockwise several turns to loosen it. Next, pull the Handle and insert the Seat Bracket (11) into the Seat Frame (8). Engage the Handle into one of the holes in the Seat Bracket, and then turn the Handle clockwise until it is tight. 58. Press two 20mm x 40mm Inner Caps (116) and a 58 25mm x 40mm Square Inner Cap (117) into the Backrest Bracket (13). Attach the Butterfly Backrest (15) to the Backrest Bracket (13) with four M6 x 16mm Screws (114). Turn the indicated Adjustment Handle (65) counterclockwise several turns to loosen it. Next, pull the Handle and insert the Backrest Bracket (13) into the Butterfly Upright (3). Engage the Handle into one of the holes in the Backrest Bracket, and then turn the Handle clockwise until it is tight. 16 116 11 116 114 117 97 99 8 65 116 3 15 114 65 117 114 13 116 59. Wet one end of the Squat Arm (32) with soapy water. Slide a Short Pad (20) onto the Squat Arm as shown. Attach a Squat Handle (33) to the Squat Arm (32) with two M8 x 20mm Button Head Screws (51). Slide an Outer Cap w/Hole (111) onto the Squat Handle and press it onto the end of the Squat Arm. Wet the Squat Handle with soapy water. Slide an 200mm Handgrip (84) onto the Squat Handle. Repeat this step with the other end of the Squat Arm (32). 60. Attach the Squat Arm (32) to the Squat Bracket (37) with two M10 x 65mm Carriage Bolts (110) and two M10 Nylon Locknuts (87). Do not tighten the Locknuts yet. Finish attaching the Squat Arm (32) to the Squat Bracket (37) with two M10 x 70mm Carriage Bolts (106), two M10 Washers (91), and two M10 Nylon Locknuts (87). Tighten all of the M10 Nylon Locknuts (87) used in this step. 59 20 32 51 20 51 33 111 84 60 87 91 87 91 32 110 106 37 20