Weider Pro 4950 English Manual - Page 15

21. Apply grease to tw0 M10 x 82mm Bolts (84) 21 and to the indicated locations on the Leg Press Frame (123) and the Front Leg Press (132). Attach the Leg Press (124) to the Leg Press Frame and the Front Leg Press Frame (123, 132) with the two Bolts (84) and two M10 Nylon Locknuts (77). Grease Grease 84 123 124 77 132 22. Apply grease in the locations shown. Insert a 22 57mm Spacer (69) into the indicated hole in the Leg Lever (12). Attach the Leg Lever to the Front Leg (10) with an M10 x 60mm Bolt Set (116). Make sure the barrel of the Bolt Set is inserted through both sides of the bracket on the Front Leg. Make sure the indicated rod is oriented as shown. See the left inset drawing. Attach the Lock Plate (14) to the Front Leg (10) with the M8 x 69mm Shoulder Bolt (87), an M8 Washer (103), and an M8 Nylon Locknut (78). Grease Bracket 116 69 Grease 116 10 12 Rod See the right inset drawing. Insert the Lock Plate Pin (95) through the Lock Plate (14) and the Leg Lever (12). Attach the tether on the Lock Plate Pin to the Front Leg (10) with an M4 x 12mm Self-tapping Screw (102). 103 10 14 78 14 102 12 23. Orient a Press Arm Handle (17) with the 90° bend at the top as shown in the inset drawing. Attach the Press Arm Handle to the Right Press Arm (16) with two M10 x 65mm Button Bolts (106), four M10 Washers (80), four 11mm Spacers (99), and two M10 Nylon Locknuts (77). Repeat this step for the Left Press Arm (not shown). 87 23 80 99 99 106 80 99 106 90° Bend 95 10 77 80 99 17 16 17 15