Weider Pro 5000 Uk Manual - Page 9

8. Attach the Press Arm (8) without the wire to the Upright (3) with four M10 x 25mm Screws (58). Remove the M4 x 5mm Screw (69) and the Swivel Arm (16). Route the Press Arm Cable (30) through the Swivel Arm and the Press Arm (8) as shown. Reattach the Swivel Arm (16) to the Press Arm (8) with the M4 x 5mm Screw (69). 8 3 8 58 16 30 69 58 9. Attach a "V"-pulley (22) to a Swivel Arm (16) with an M10 x 64mm Button Bolt (75), two M10 9 Washers (71), two 5mm Spacers (25), and an M10 Nylon Locknut (73). Make sure the Press Arm Cable (30) is routed under the indicated welded rods. Welded 16 Rod 71 73 30 75 71 25 25 Welded Rod 22 10. Attach a 2 3/4" Pulley (23) to the left Press Arm (8) with an M10 x 53mm Button Bolt (61), two M10 Washers (71), two 5mm Spacers (25), two Finger Guards (27), and an M10 Nylon Locknut (73). See the inset drawing. Orient the finger guards and pulley as shown. Make sure the Press Arm Cable (30) is in the groove of the Pulley. 10 27 23 27 27 23 73 30 71 27 25 25 71 8 61 9