Weider Pro 545 English Manual - Page 14
Adjusting The Weider Pro 545 - exercises
View all Weider Pro 545 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
ADJUSTING THE WEIDER PRO 545 The weight bench is designed to be used with your own weight set (not included). The steps below explain how the weight bench can be adjusted. See EXERCISE GUIDELINES on page 17 for important exercise information and refer to the accompanying exercise poster to see the correct form for each exercise. Refer also to the exercise information accompanying your weight set (not included) for additional exercises. Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. ADJUSTING THE BACKREST The Backrest (29) can be set at four different positions: the level position, the decline position, and two incline 29 positions. To change the position of the Backrest (29), remove the "L" Pin (46) from the Adjustment Bracket (26) and the Bench Frame (49). Set the Backrest to the desired position, align the holes in the Adjustment Bracket and the Bench Frame, and re-insert the "L" Pin. 26 49 46 ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE To use the pulley station, slide the desired amount of weight (not included) onto the weight tube on each Weight Carriage (52). Be sure there is an equal amount of weight on each Weight Carriage. Secure the weights on each Weight Carriage with a Spring Clip (47). WARNING: Do not place more than 75 pounds on each weight carriage. 52 Weight 47 Weight Tube ATTACHING WEIGHTS TO THE LEG LEVER To use the Leg Lever (32), slide the desired amount of weight (not included) onto the weight tube. Secure the weight with a Spring Clip (47). WARNING: Do not place more than 150 pounds on the leg lever. 32 Weight 47 Weight Tube 14