Weslo Cadence G-40 Treadmill English Manual - Page 10
If The Connectors Are Not Con
View all Weslo Cadence G-40 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
9. With the help of a second person, hold the 9 Console (91) near the Right Upright (54). Connect the Wire Harness (39) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Remove the wire tie from the Wire Harness. Insert the connectors and the excess wire downward into the Right Upright (54). 91 Console Wire 39 Console Wire 54 39 10. Set the Console (91) on the Uprights (53, 54). 10 Make sure that no wires are pinched. Start 91 four M8 x 15mm Bolts (8) with four M8 Star Washers (5) into the Uprights as shown. Do not tighten the Bolts yet. 11. Start an M8 x 15mm Bolt (8) with an M8 Star Washer (5) into each Upright (53, 54). Then, firmly tighten all six M8 x 15mm Bolts (8). With the help of a second person, carefully lower the Uprights (53, 54) to the floor. 8 5 54 11 85 8 53 8 5 53 8 54 85 10