Weslo Cadence G-40 Treadmill English Manual - Page 7
Attach the Left Upright 53 to the Base 52
View all Weslo Cadence G-40 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2. Have a second person hold the Base (52) in the position shown. 2 Identify the Right Upright (54), which has a large hole near the lower end. Large Hold the Right Upright (54) so that the large hole is oriented as shown. Attach the Right Hole 54 2 Upright to the Base (52) with two M10 x R0710Amm Bolts (2). Do not tighten the Bolts yet. 52 2 Attach the Left Upright (53) to the Base (52) in the same way. Small Holes 53 3. Slide the two Wheel Housings (45) onto the Base (52). Attach each Wheel Housing with two M6 x R0710Amm Bolts (13), two M6 Flat Washers (32), and two M6 Nuts (43). 3 32 45 43 13 32 45 13 52 32 43 32 4. Remove and discard the bolts and the card- 4 board packaging from both sides of the Hood (65). Position the Base (52) as close to the front of the treadmill as possible. See the inset drawing. Locate the wire tie in the Right Upright (54). Tie the wire tie securely to the connector on the end of the Wire Harness (39). Next, pull the opposite end of the wire tie out of the upper end of the Right Upright, until the Wire Harness is routed completely through the Right Upright. Secure the Wire Harness to the upper end of the Right Upright so that it will not fall inside. 39 Wire Tie 54 65 54 39 Wire Tie 52 7