Weslo Pursuit 360r Bike English Manual - Page 15

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise cycle reg- When the Reed Switch is correctly adjusted, reattach ularly. Replace any worn parts immediately. the left shield and the left pedal. To clean the exercise cycle, use a damp cloth and a small amount of mild detergent. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. HOW TO ADJUST THE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is at the highest level, the belt may need to be adjusted. BATTERY REPLACEMENT If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, see assembly step 9 on page 9. HOW TO ADJUST THE REED SWITCH To adjust the belt, you must first remove the right pedal and the right shield. Using an adjustable wrench, turn the right pedal counterclockwise and remove it. Next, remove all the screws from the left and right shields; there are two sizes of screws in the shields-note which size of screw you remove from each hole. Then, gently pull the right shield away from the frame. If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must first remove the left pedal and the left shield. Using an adjustable wrench, turn the left pedal clockwise and remove it. Next, remove all the screws from the left and right shields; there are two sizes of screws in the shields-note which size of screw you remove from each hole. Then, gently pull the left shield away from the frame. Next, turn the resistance knob to the lowest setting. Loosen the Flywheel Axle (39). Next, tighten the M6 Locknuts (63), one on each side of the Flywheel (37), until the Drive Belt (35) is tight. Then, tighten the Flywheel Axle and reattach the right shield and the right pedal. 37 35 Locate the Reed Switch (43). Turn the Crank (21) until the Magnet (38) is aligned with the Reed Switch. Loosen, but do not remove, the M4 x 15mm Self-tap- ping Screw (47). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the 63 Screw. Turn the Crank for a moment. Repeat until the console displays correct feedback. 39 43 38 47 21 15