Weslo Pursuit G 2.8 Bike English Manual - Page 12

12

When you turn

on the console,

the scan mode

will be selected

automatically.

One indicator will

appear below the

word Scan to

show that the

scan mode is

selected, and a second indicator will show which

information is currently displayed. Note: If you

have selected a different mode, press the Display

button repeatedly to reselect the Scan mode.

To select the

speed, time, dis-

tance, or calories

mode for contin-

uous display,

press the Display

button repeated-

ly. The indicators

will show which mode is selected. Make sure that

there is not an indicator below the word Scan.

Note: The con-

sole can show

speed and dis-

tance in either

miles or kilome-

ters.

The letters

“mph” or “km/h”

will appear in the

display to show which unit of measurement is

selected. To change the unit of measurement, first

hold down the On/Reset button for a few seconds.

An “E” (for English) or an “M” (for metric) will

appear in the display. Press the Display button to

change the unit of measurement. Note: When the

batteries are replaced, it may be necessary to res-

elect the desired unit of measurement.

To reset the display, press the On/Reset button.

To pause the console, stop pedaling. If the time is

displayed, it will flash. To continue your workout,

simply resume pedaling.

4.

Measure your heart rate if desired.

To measure your

heart rate,

stop

pedaling

and

place your thumb

on the pulse sen-

sor.

Do not

press too hard,

or the circula-

tion in your thumb will be restricted and your

pulse will not be detected.

After a few seconds,

the heart-shaped indicator in the display will begin

to flash, two dashes will appear, and then your

heart rate will be shown. Hold your thumb on the

pulse sensor for about 15 seconds for the most

accurate reading.

If the displayed heart rate appears to be too high

or too low, or if your heart rate is not displayed, lift

your thumb off the pulse sensor for a few seconds.

Then, place your thumb on the pulse sensor as

described above.

Make sure that you are applying the proper

amount of pressure to the pulse sensor. Try the

pulse sensor several times until you become famil-

iar with it. Remember to stand still while measur-

ing your heart rate.

5.

When you are finished exercising, the console

will turn off automatically.

If the pedals do not move for a few seconds, the

console will pause. If the pedals do not move for a

few minutes, the console will turn off and the dis-

play will be reset.

Indicators

Weslo Pursuit G 2.8 Bike English Manual - Page 12

Note: The con

Page 12 highlights