Weslo Pursuit G 2.8 Bike English Manual - Page 7

4. Turn the Seat Knob (9) counterclockwise and 4 remove it from the Frame (1). Next, insert the Seat Post (5) into the Frame (1). Adjust the Seat Post to the desired height, and insert the Seat Knob (9) into the indicated hole in the Frame and into one of the adjustment holes in the Seat Post. Then, turn the Seat Knob clockwise until it is tight. Make sure the Seat Knob is firmly engaged in one of the adjustment holes in the Seat Post. 5 Adjustment Holes 1 Hole 9 5. While another person holds the Upright (13) near the Frame (1) as shown, connect the Extension Wire (23) to the Reed Switch Wire (39). Next, connect the Resistance Cable (19) to the Lower Cable (29) in the following way: • See drawing A. Pull up on the metal bracket on the Lower Cable (29), and insert the tip of the Resistance Cable (19) into the wire clip inside of the metal bracket as shown. • See drawing B. Firmly pull the Resistance Cable (19) upward and slide it into the top of the metal bracket as shown. • See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together. Push the Wires (23, 39) and the Cables (19, 29) downward into the Frame (1). Tip: Avoid pinching the wires and cables. Next, insert the Upright (13) into the Frame (1). Attach the Upright with three M8 x 15mm Button Screws (34) and three M8 Split Washers (42). 5 13 19 29 34 42 A Avoid pinching the wires and cables 23 39 42 34 1 B C Metal Bracket 19 29 Metal 19 Bracket 7