Whirlpool GI6SDRXXB User Instructions - Page 8

CoolingOn/Off: • CoolinOg n/OftfurnsoffcoolinfgorbothcompartmenIts. doesnotdisconnepcot wetrotherefrigerator. • PressandholdCoolinOg n/Offor3secondsT.heLEDwill lightupto indicattehatcoolingisOff.Pressthebuttonagain toturnonthecoolingT.heLEDwillturnoff. ® @ R_frigerat o_ Cooling Off Press 3 5ec Humidity Control The humidity control feature turns on a heater to help reduce moisture on the door hinge seal. Use in humid environments or when you notice moisture on the door hinge seal. The refrigerator uses more energy when Humidity Control is on. • Press Humidity Control to turn on the door heater. Press Humidity Control again to turn off the heater. The LED will be illuminated when Humidity Control is on. @® ° HUMIDITY CONTROL Adjusting Controls The REFRIGERATOR control adjusts the refrigerator compartment temperature. The FREEZER control adjusts the freezer compartment temperature. If you need to adjust the temperature in either the refrigerator or freezer compartment, use the settings listed in the chart as a guide. To Adjust Set Point Temperatures: The first touch of the (+) or (-) touch pad displays the current temperature set point. • Press the (+) or (-) touch pads until the desired temperature set point is displayed. NOTE: Except when first turning on the refrigerator, do not adjust either temperature control more than one setting at a time. Wait 24 hours between adjustments for the temperature to stabilize. CONDITION/REASON: ADJUSTMENT: REFRIGERATOR too warm REFRIGERATOR Control 1° lower FREEZER too warm/too little ice FREEZER Control 1° lower REFRIGERATOR too cold FREEZER too cold REFRIGERATOR Control 1° higher FREEZER Control 1° higher Additional Control Center Features Fast Cool The Fast Cool feature assists with periods of high refrigerator use, full grocery loads, or temporarily warm room temperatures. • Press the Fast Cool touch pad to set the freezer and refrigerator to the lowest temperature settings. Press the Fast Cool touch pad again to return to the normal refrigerator set point. NOTE: The Fast Cool feature will automatically shut off in approximately 2 hours. When Fast Cool is on, the temperature cannot be adjusted. ®® FAST COOL Door Alarm The Door Alarm feature sounds a chime every few seconds when the refrigerator door has been left open for 5 continuous minutes. The chime will sound until the door is closed or Door Alarm is turned off. • Press the Door Alarm touch pad to turn this feature on or off. The indicator light will be lit when the Door Alarm feature is on. ®® DOOR ALARM Filter Reset The Filter Reset control allows you to restart the water filter status tracking feature each time you replace your water filter. See "Water Filtration System." • Press and hold the Filter Reset touch pad for 3 seconds, until the Order or Replace light turns off. ORDE_P_-ACE FILTER RESET _EssANO_OtD User Preferences The control center allows you to set user preferences, if desired. Temperature Display (F C) This preference allows you to change the temperature F - Temperature in degrees Fahrenheit C - Temperature in degrees Celsius display. Alarm (AL) This preference allows you to turn off the sound of all alarms. ON - You will hear the alarm sound. OFF - You will not hear the alarm sound. Auto Light Level Selection (LL) This preference allows you to adjust the dispenser light level from dimmest to brightest (settings 1 through 9). NOTE: The Auto Light feature on the control center must be selected to activate this preference. Sabbath Mode (SAD) ON - All control center lights, interior lights and alarm tones will be disabled. OFF - All control center lights, interior lights and alarm tones will be enabled. NOTE: Press the door alarm touch pad for 3 seconds to restore all lights. 8