Whirlpool UXD8630DYS Installation Guide - Page 12
Complete Installation
View all Whirlpool UXD8630DYS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
4. Lift the ¼" (6.4 mm) deep cover off the shoulder screws in the keyhole slots and set the cover aside. 5. Remove the screws from the wire mounting plate. A A B C A. Screws B. Wire mounting plate C. Blower motor box 6. Hold the wire mounting plate and push the grommet out of the mounting plate. A Complete Installation NOTE: The downdraft vent system is supplied with a 3¹⁄₄" x 10" (8.3 x 25.4 cm) back draft damper and a 6" (15.2 cm) round vent transition with damper. Refer to "3¹⁄₄" x 10" (8.3 x 25.4 cm) back draft damper" or "6" (15.2 cm) round vent transition with damper," depending upon the type of venting you are using. 3¹⁄₄" x 10" (8.3 x 25.4 cm) Back Draft Damper 1. Attach the 3¼" x 10" (8.3 x 25.4 cm) back draft damper to the vent opening in the blower motor box, using three 3.5 x 9.5 mm screws. BA A A. 3.5 x 9.5 mm screws B. 3¼" x 10" (8.3 x 25.4 cm) back draft damper 6" (15.2 cm) Round Vent Transition With Damper 1. Attach the 6" (15.2 cm) round vent transition to vent opening (left or right side venting only is recommended), using two 3.5 x 9.5 mm screws. B A. Wire mounting plate B. Grommet 7. Slide the wire assembly through the slot in the wire mounting plate to remove it. 8. Place the wire assembly through the opening to the opposite side of the vent box. 9. Reassemble the wire assembly and grommet to the wire mounting plate. 10. Install the wire mounting plate to the vent box using the 4 screws previously removed. 11. Place the blower motor box assembly with the keyhole slots over the 2 shoulder screws on the rear of the vent box and reconnect the wire connection to the blower motor. 12. Mount the blower motor box to the vent box and secure using the 6 screws previously removed. 13. Mount the 4³⁄₄" (12.0 cm) cover box (supplied) to the front of the vent box. Place the keyhole slots over the 2 shoulder screws, align the mounting holes, and secure the cover box to vent box using the 6 screws previously removed from the ¼" (6.4 mm) deep cover. 14. Go to the "Complete Installation" section. 12 A B A. 3.5 x 9.5 mm screws B. 6" (15.2 cm) round vent transition with damper