Whirlpool UXD8630DYS Installation Guide - Page 13

2. Remove 4 screws attaching the terminal box cover. A 5. Drill 2 pilot holes through each of the undercounter mounting brackets into the underside of the countertop. Using 2 screws (not provided) of the appropriate length, mount the brackets to the countertop. IMPORTANT: Select a screw length that will not allow the screws to go through the countertop when tightened. B C A. Terminal box cover 3. Determine which direction (front or rear) the home power supply cable will enter the terminal box. Remove the appropriate knockout from the front or rear panel and install a ¹⁄₂" (12.7 mm) UL listed or CSA approved conduit connector. 4. Using 2 or more people, insert the downdraft vent into the countertop cutout. Position downdraft vent so it is centered in the cutout with the rear flange over the edge of the cutout and the rear of the vent box against the edge of the cutout. A A A. Screws B. Backsplash C. Countertop 6. Check that the downdraft vent is level vertically. Loosen the lower support legs screws and position the legs against the cabinet floor. 7. Fasten the lower support legs to the cabinet floor with screws (not provided). G B C D E F A. Rear flange of downdraft vent B. Edge of cutout in countertop C. Rear of downdraft vent D. Cabinet back E. Lower support leg F. Cabinet floor G. Countertop A A. Screw (not provided) 8. Tighten the lower support legs screws. Make Electrical Connections WARNING Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 1. Disconnect power. 13