Whirlpool WDF518SAH Installation Instructions - Page 13

17. Power cord-reinstall terminal box cover and wires Terminal box cover 19. Stand dishwasher upright Water line Drain Place wires inside terminal box. Replace the cover by inserting the hooks of the terminal cover into the slots in the floor of the terminal box and sliding the cover tight against the back wall where wires come in. Make sure wires are tucked inside the box and not pinched by the cover. NOTE: Route power cord out the bottom rear channel provided. Do not plug cord into an outlet until instructed to do so. UTILITY ROUTING CHANNEL LOCATION 18. Water supply hose, power cord channel routing locations Cable Using two or more people, stand the dishwasher up. NOTE: Do not install kick plate until instructed to do so. Dishwasher may fit tightly into cabinet opening. Do not remove insulation blanket-the blanket reduces the sound level. NOTE: Route water supply, drain hose, and power cord out the rear of the dishwasher. 20. Move dishwasher close to cabinet opening Fill valve Route water supply hose and electrical supply through the channels in the bottom of base as shown. Channels Junction box Route the utilities through the holes in the cabinet, and pull the slack out at the same time as the dishwasher is pushed into the cabinet 21. Route power cord Hose Electrical cord Route the water supply and electrical supply to the back of the unit through the bottom base channels provided. Secure utilities in channel using tape or wire ties. WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. If using a power cord, make sure to route the end through hole in cutout before sliding dishwasher into the cabinet opening. 13