Whirlpool WFW72HEDW Use & Care Guide - Page 14
WASHER CARE cont.
View all Whirlpool WFW72HEDW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Washer Maintenance WASHER CARE (cont.) Description of Clean Washer with affresh® Cycle Operation: 1. The Clean Washer with affresh® cycle will determine whether clothing or other items are in the washer. 2. If no items are detected in the washer, it will proceed with the cycle. a. If any items are detected in the washer, "rL" (remove load) will be displayed. The door will unlock. Open washer and remove any garments from the washer drum. b. Touch POWER to clear the "rL" code. c. Touch and hold START to restart the cycle. 3. Steam models only: During the first 20 minutes of the cycle, it will activate the steamer but the drum will not spin or fill with water. You may see condensation on the door glass during this initial phase. If you are using an affresh® Washer Cleaner tablet, it will not dissolve completely during the steam phase. This is normal. After the cycle is complete, leave the door open slightly to allow for better ventilation and drying of the washer interior. Cleaning the Dispensers After a period of using your washer, you may find some residue buildup in the washer's dispensers. To remove residue from the dispensers, remove the drawer and wipe the surfaces with a damp cloth and towel dry either before or after you run the Clean Washer with affresh® cycle. Use an all-purpose surface cleaner, if needed. IMPORTANT: Dispenser is not dishwasher safe. Cleaning the Outside of the Washer Use a soft, damp cloth or sponge to wipe up any spills. Occasionally wipe the outside of your washer to help keep it looking new. Use mild soap and water. IMPORTANT: To avoid damaging the washer's finish, do not use abrasive products. WASHER CARE (cont.) Removing the Dispenser To remove: 1. Pull dispenser drawer out until it stops. 2. Press down on the release tab and pull straight out to remove the dispenser. 3. Lift off cover panel by pulling straight up. To replace: 1. Slide cover panel back onto posts on dispenser. 2. Align edges of dispenser with guides in washer, then slide dispenser back into slot. 14