Xerox 750DX Fiery SI Color Server Administration Guide - Page 28
Setup, Printer Setup, and then Job Log Setup., Turn on the Fiery SI.
UPC - 042215455060
View all Xerox 750DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
22-4 Setting up the Fiery SI For software update or setup, press any key. 4. At the startup message, press any button. The Start Up screen is displayed. Run Setup Install Software Format Disk Start Up 5. Choose Run Setup to access all setup menus. The Install Software and Format Disk commands are for service technicians. Exit Setup Server Setup Network Setup Printer Setup Setup Job Log Setup Calibration Change Password Clear Server Setup 6. Press the line selection button to choose a Setup menu or command. Press the down arrow to view the second screen of the main Setup menu. 7. Choose setups in the same order as they appear in the menu: Server Setup, Network Setup, Printer Setup, and then Job Log Setup. The sequence is important for first-time setup. Later, just go directly to the menu you want to change. However, if you make changes in Network Setup, you may need to change some settings in Printer Setup as well. NOTE: If you make changes in Server, Network, or Printer Setup, you'll need to update the system configuration by opening and saving the other setups even if you haven't changed any other settings. TO ACCESS SETUP WHEN THE FIERY SI IS OFF: 1. Make sure the Fiery SI is connected to the copier/printer and connected to the network you will use. 2. Turn on the Fiery SI. The startup diagnostics are performed. 3. At the startup message, press any button. 4. Continue with step 5 from the previous procedure. Review the settings described in this chapter. For more information on calibration, and on Control Panel screens other than those in the Setup, see the User Guide.