Xerox 750DX Fiery SI Color Server Administration Guide - Page 97
Network Setup messages, Administering the Fiery SI, After this Setup screen, This message, Means
UPC - 042215455060
View all Xerox 750DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
44-4 Administering the Fiery SI Network Setup messages After this Setup screen: This message: Enable AppleTalk (AppleTalk Setup) No AppleTalk zone found. Network Setup, after choosing Parallel (Input) must be Parallel Port Setup enabled in Server Setup. Maximum Frame Size (Token Ring Setup) Token Ring hardware not installed or not functioning. Select File Server From List Initialization failed. Check all connections. No NetWare file server found. Enter First Letters of Server Name File server name not found. Try again? View Server List, Edit Connection Add File Server No file server is selected. All connections used. Remove server? Means: The Ethernet network cable is not attached to the connector on the Fiery SI. If your AppleTalk network has zones, and you want to specify a zone for the Fiery SI, you must connect the network cable to the Fiery SI before performing AppleTalk Setup. Also could mean that the AppleTalk network doesn't have zones. Zones are not required for printing to the Fiery SI. Press OK to continue. Before you can configure your parallel port settings, you must enable the parallel port in Server Setup. Choose Exit Network Setup, and then choose Server Setup. Fiery SI queries the Token Ring hardware. Error indicates that some components are not installed, are not installed correctly, or not installed in the correct device. An unsupported Token Ring board may be in use. Check with your authorized service/support center. Fiery SI is unable to configure and use the token ring hardware. Check with your authorized service/support center. No file server was found when Fiery SI queried the network to create a list of supported servers or a list of all servers. Check cable connections and make sure the NetWare server is turned on. No file server with those letters was found when Fiery SI queried the network. Check the name of the NetWare file server, and check cable connections to make sure the NetWare server is turned on. No file server has been added in Network Setup. You have added the maximum number of NetWare file servers, which is eight for Ethernet plus eight for token ring.