Yamaha DSP-A592 Owner's Manual - Page 24
To listen to a decoded source using Dolby, Digital AC-3 by reproducing the signals input
View all Yamaha DSP-A592 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Notes on using the input selector buttons DSP-A592 q Note that pressing on each input selector button selects the source which is connected to the corresponding input terminals on the rear panel. * To select the source connected to the VIDEO AUX terminals on the front panel, press VIDEO AUX. q The selection of TAPE (MD) MON cannot be canceled by pressing another input selector button. To cancel it, press TAPE (MD) MON again so that "TAPE MONITOR" disappears from the display. When you select a button other than TAPE (MD) MON, make sure that "TAPE MONITOR" is not illuminated on the display. q If you select the input selector button for a video source without canceling the selection of TAPE (MD) MON, the playback result will be the video image from the video source and the sound from the audio tape (or MD etc.). q Once you play a video source, its video image will not be interrupted even if the input selector button for an audio source is selected. DSP-A492 q Note that pressing on each input selector button selects the source which is connected to the corresponding input terminals on the rear panel. q The selection of TAPE (MD) MONITOR cannot be canceled by pressing another input selector button. To cancel it, press TAPE (MD) MONITOR again so that "TAPE MON" disappears from the display. When you select a button other than TAPE (MD) MONITOR, make sure that "TAPE MON" is not illuminated on the display. q If you select the input selector button for a video source without canceling the selection of TAPE (MD) MONITOR, the playback result will be the video image from the video source and the sound from the audio tape (or MD etc.). q Once you play a video source, its video image will not be interrupted even if the input selector button for an audio source is selected. DSP-A592 only To listen to a decoded source using Dolby Digital (AC-3) by reproducing the signals input to the 6CH DISCRETE INPUT DVD/LD TV/DBS terminals of this unit. In step 3, select TV/DBS or DVD/LD, and then press the 2CH/6CH button so that "6ch" appears on the display. Discrete signals from the unit connected to the 6CH DISCRETE INPUT DVD/LD TV/DBS terminals of this unit are selected as the input signals. 2CH/6CH To cancel it, press the 2CH/6CH button again or select another input source. Note for reproducing discrete signals with Dolby Digital (AC-3) decoded: 1. Your speaker system must include a center speaker. 2. Your speaker system must include a subwoofer. * Connect a subwoofer which has a built-in amplifier to the SUBWOOFER OUTPUT terminal of this unit. * You can do without using a subwoofer. If you do so, you should make a setting for distributing signals at the LFE channel to the right and left MAIN output terminals on the Dolby Digital (AC-3) Decoder unit. For details, refer to the owner's manual for the Dolby Digital (AC-3) Decoder unit. Notes q When you switch to the "6CH" mode, the built-in Digital Sound Field processor will not work and adjustment of delay time cannot be made. q Switching this unit to the "6CH" mode will input no signal to this unit if there is no connection to the 6CH DISCRETE INPUT DVD/LD TV/DBS terminals of this unit. 24