Yamaha MG20XU Owner's Manual - Page 25

STEREO OUT] jacks, PHONES] jack, MONITOR] Controls and Connectors, selection switch - 20 channel mixer

Page 25 highlights

r [STEREO OUT] jacks These are XLR type and TRS phone-type balanced output jacks that output the mixed stereo signal. The signal level is adjusted by the [STEREO] master fader before it is output. You can use these jacks, for example, to connect to the power amplifier driving your main speakers. t [PHONES] jack Controls and Connectors • [POWER] indicator This indicator lights up when the mixer's power is on ( ). • Level meter The level meter LED shows the level of the signal in the STEREO L/R and GROUP buses, or selected with [PFL] switches. The "0" (< ) segment corresponds to the nominal output level. The level meter [PEAK] indicator lights when output reaches the clipping level. • [PFL] indicator When the [PFL] switch is on, the indicator flashes. PFL L PFL R PFL CTRL Connect a pair of headphones to this TRS phone jack. NOTE • The [PHONES] jack outputs the same signal as the [MONITOR OUT] jacks. • When the [PFL] indicator is flashing, the signal for channels where the [PFL] switch is pressed is output. When the [PFL] indicator is off, the signal for the buses selected in the [MONITOR] section y is output. y [MONITOR] section STL MONI STR MONI G1 MONI G2 MONI MG12XU/ MG12 MG20XU/MG20 MG16XU/MG16 G3 MONI 1-2/3-4 G4 MONI STEREO/ GROUP POWER PEAK +10 +6 +3 0 -3 -6 -10 -15 -20 -25 -30 PFL PHONES MONITOR PHONES [3mW 40ohms] MONITOR OUT L [+4dBu] MONITOR OUT R [+4dBu] MG20XU/MG20 MG16XU/MG16 MG12XU/MG12 • [MONITOR LEVEL] knob For adjusting the level of the signal output to the [MONITOR OUT] jack. • [PHONES] knob For adjusting the level of the signal output to the [PHONES] jack. • [SOURCE]/[SOURCE SELECT] (Monitor signal selection switch) Sets the signal sent to the [MONITOR OUT] jack, [PHONES] jack, and level meter. You can use this switch to select the signal from the STEREO L/R buses, GROUP 1-2 buses, or GROUP 3-4 buses (MG20XU/MG20/MG16XU/MG16). • MG12XU/MG12 STEREO L/R buses: [STEREO] ( ) GROUP 1-2 buses: [GROUP] ( ) • MG20XU/MG20/MG16XU/MG16 STEREO L/R buses: [STEREO] ( ) GROUP 1-2 buses: [GROUP] ( ), [1-2] ( ) GROUP 3-4 buses: [GROUP] ( ), [3-4] ( ) MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner’s Manual
25
Controls and Connectors
r
[STEREO OUT] jacks
These are XLR type and TRS phone-type balanced output
jacks that output the mixed stereo signal. The signal level is
adjusted by the [STEREO] master fader before it is output.
You can use these jacks, for example, to connect to the power
amplifier driving your main speakers.
t
[PHONES] jack
Connect a pair of headphones to this TRS phone jack.
NOTE
The [PHONES] jack outputs the same signal as the [MONI-
TOR OUT] jacks.
When the [PFL] indicator is flashing, the signal for channels
where the [PFL] switch is pressed is output. When the [PFL]
indicator is off, the signal for the buses selected in the [MON-
ITOR] section
y
is output.
y
[MONITOR] section
• [POWER] indicator
This indicator lights up when the mixer’s power is on
(
).
• Level meter
The level meter LED shows the level of the signal in
the STEREO L/R and GROUP buses, or selected with
[PFL] switches. The “0” (
<
) segment corresponds to
the nominal output level. The level meter [PEAK] indi-
cator lights when output reaches the clipping level.
• [PFL] indicator
When the [PFL] switch is on, the indicator flashes.
• [MONITOR LEVEL] knob
For adjusting the level of the signal output to the
[MONITOR OUT] jack.
• [PHONES] knob
For adjusting the level of the signal output to the
[PHONES] jack.
• [SOURCE]/[SOURCE SELECT] (Monitor signal
selection switch)
Sets the signal sent to the [MONITOR OUT] jack,
[PHONES] jack, and level meter. You can use this
switch to select the signal from the STEREO L/R
buses, GROUP 1-2 buses, or GROUP 3-4 buses
(MG20XU/MG20/MG16XU/MG16).
• MG12XU/MG12
STEREO L/R buses: [STEREO] (
)
GROUP 1-2 buses: [GROUP] (
)
• MG20XU/MG20/MG16XU/MG16
STEREO L/R buses: [STEREO] (
)
GROUP 1-2 buses: [GROUP] (
), [1-2] (
)
GROUP 3-4 buses: [GROUP] (
), [3-4] (
)
PHONES
MONITOR
PFL L
PFL R
PFL CTRL
STR MONI
STL MONI
G2 MONI
G3 MONI
G4 MONI
G1 MONI
MG20XU/MG20
MG16XU/MG16
MG12XU/
MG12
1-2/3-4
STEREO/
GROUP
POWER
PEAK
+10
+6
+3
0
-3
-6
-10
-15
-20
-25
PFL
-30
PHONES
[3mW 40ohms]
MONITOR OUT L
[+4dBu]
MONITOR OUT R
[+4dBu]
MG20XU/MG20
MG16XU/MG16
MG12XU/MG12