Yamaha MG20XU Owner's Manual - Page 28
USB Block (XU Models Only), Attenuator Function - driver
View all Yamaha MG20XU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Controls and Connectors USB Block (XU Models Only) only MG20XU/MG16XU/MG12XU USB-REC-L USB-REC-R USB Audio Controller USB-Att. • [USB 2.0] jack (USB-Att.) USB-PLAY-L USB-PLAY-R NOTICE • Use an A/B type USB cable. The cable should be no more than 1.5 meters long. A USB 3.0 cable cannot be used. • Be sure to wake the computer from sleep/suspended/ standby mode before making a connection to the computer's [USB 2.0] connector. • Connect the mixer to the computer before turning the mixer power on. • Always perform the following two operations before turning the mixer's power on or off, or connecting or disconnecting the USB cable. - Exit all applications. - Confirm that no data is being sent from the mixer. • Allow at least six (6) seconds between turning the mixer on or off, and plugging or unplugging the USB cable. Connects to a computer via a USB cable. The signal from the STEREO L/R buses is output to the computer. (This signal is not affected by the [STEREO] master fader.) A USB driver might be required for computer input/output. You can download the driver from the following Yamaha website, and install it on your computer. http://www.yamahaproaudio.com/mg_xu When the [ST] switch of a channel which has a [LINE / USB ] switch is on while DAW software is being used, a loop is formed and feedback or howling may result. [USB 2.0] Connection Precautions Be sure to observe the following points when connecting to a computer's [USB 2.0] interface. Failure to observe these rules can result in computer freezes/hang-ups and possibly data loss or corruption. If the mixer or computer does hang up, restart the application and/or computer and turn the power to the mixer off and then on again. Attenuator Function The [PROGRAM] knob e (page 22) can be used to adjust the volume of audio playback from a computer. 1. Press the [PROGRAM] knob five times consecutively to display the attenuation value (dB). 2. Turn the [PROGRAM] knob to set it between -24 dB to 0 dB. (The minus sign is not displayed.) 3. Press the [PROGRAM] knob again to exit the setting. When the attenuator is enabled, the dot lights at the lower right of the display. 28 MG20XU/MG20/MG16XU/MG16/MG12XU/MG12 Owner's Manual