Yamaha MW12CX Owners Manual - Page 18

Reference Front & Rear Panels Master Control Section 2 1 6 4 7 5 3 8 B 9 0 C A D E G F H MW12CX * impedance balanced Since the hot and cold terminals of impedance balanced output jacks have the same impedance, these output jacks are less affected by induced noise. 18 MW12CX/MW12C Owner's Manual 1 2TR IN Jacks These RCA pin jacks can be used to input a stereo sound source. Use these jacks when you want to connect a CD player directly to the mixer. NOTE • Select where you want to send the signal using the 2TR IN/USB switch E, and adjust the signal level using the 2TR IN/USB control in the Master Control section. • A signals input via both the 2TR IN input and the USB input are mixed. 2 REC OUT 1 (L, R) Jacks These are RCA pin jacks that can be used to connect to an external stereo recorder. The signal processed by the REC OUT fader is output via these jacks. 3 REC OUT 2 (L, R) Jacks These are impedance-balanced TRS phone jacks that can be used to connect to an external stereo recorder. The signal processed by the REC OUT fader is output via the these jacks. 4 RETURN L (MONO), R Jacks These are unbalanced phone-jack type line inputs. The signal received by these jacks is sent to the STEREO L/R bus and the AUX (AUX1) bus. These jacks are typically used to receive the signal returned from an external effect device (reverb, delay, etc.). NOTE These jacks can also be used as an auxiliary stereo input. If you connect to the L (MONO) jack only, the mixer will recognize the signal as monaural and will send the identical signal to both the L and R jacks. 5 SEND Jacks • AUX (AUX1) This is an impedance balanced* TRS phone jack that outputs the signals from AUX (AUX1) bus. You can use this jack, for example, to connect to an effect unit, cue box, or other monitoring system. • EFFECT (AUX2) This is an impedance balanced* TRS phone jack that outputs the signal from the EFFECT (AUX2) bus. You can use this jack, for example, to connect to an external effect unit. 6 STEREO OUT (L, R) Jacks These jacks deliver the mixer's stereo output. You can use these jacks, for example, to connect to the power amplifier driving your main speakers. You can also connect these jacks to a recording device when you wish to record mixer's stereo output while using the STEREO OUT Master fader H for level control. • XLR jacks XLR-type balanced output jacks. • LINE jacks TRS phone-jack type balanced outputs. 7 MONITOR OUT Jacks Connect these impedance-balanced* TRS phone jacks to your monitor system. NOTE The signal output by these jacks is determined by the MONITOR switch D, the 2TR IN/USB E, and the PFL switches on the input channels.