Yamaha NX-P120 Owners Manual - Page 57

Creating the Best Listening Space Placing the Speakers (NX-P120) To get the most out of the sound field effects you need to place the speakers in the best positions. To guard against poor acoustics like sound blur make sure the speakers are stable. Also read page 7, Preparing the Speakers. Placing the Center Speaker Peel off the seal Fastener Make sure the top of the television is level. If the top of the television is not level, place the Center Speaker inside the TV rack or directly on the floor. In any case, make sure it is placed on a level surface. When placing on top of the television, use the supplied fastener (two pieces) as shown in the picture on the left, between the bottom of the Center Speaker and top of the television to fasten. Note • Do not place on a television with top narrower than the bottom of the speaker. You may get injured if the speaker falls over. • Do not place if the top of the television is slanting. You may get injured if the speaker falls over. • After peeling off the fastener seal, do not touch the bonding surface. If you do, the bonding surface weakens, which later may cause the speaker to fall over. • Before attaching the fastener to the television, wipe the TV top clean. If the surface is dirty or wet tape will lose bonding strength, which later may cause the speaker to fall over. Placing the Subwoofer Place the Subwoofer on a level hard floor. When placing, use non-skid pads on the bottom of the Subwoofer in the four corners as shown in the picture. This will prevent the Subwoofer from sliding when it vibrates. Also, increasing stability prevents degradation of sound. Creating the Best Listening Space English 53