Yamaha NX-P120 Owners Manual - Page 81

Types of Input Signals Switching Input Modes DVR-S120 WB56650 POWER POWER TV AUDIO ANGLE SUBTITLE /DTS SELECT MATRIX 6.1 STEREO REPEAT A-B NIGHT SW CENTER SURR TV CH PRESET TV INPUT SHIFT A B C D E SLEEP PRESET ON SCREEN MENU CH STATUS TV VOL ENTER SET MENU CH RETURN MUTE TEST VOLUME DVD/CD AMP VCR VIDEO TUNER MOVIE MUSIC SPORTS GAME CINEMA You can playback most sources without a problem with the AUTO setting (factory default setting). Then depending on your needs, you can select the priority level for digital and analog input signals, and specify formats such as DTS. Press the Input Selection button for current input source until the desired input mode appears in the CinemaStation Display. AUTO: DTS: ANLG: Input signal can be selected in the order below. 1) Digital signal 2) Analog signal Only DTS can be played. Only analog signal can be played. Input Selection buttons Learning about input modes, jacks and Input Selection buttons CinemaStation can receive signals from the VIDEO (analog), VCR (analog) and OPTICAL (digital) jacks of equipment that is connected to it. You can assign a VIDEO or VCR input name to the OPTICAL IN jack. This will allow you to use the VIDEO button or VCR button to input a device connected to the OPTICAL IN jack (VIDEO is assigned in the default setting.) Normally, an analog signal is input to the VIDEO or VCR IN jack, and a digital signal is input to the OPTICAL IN jack. However, by setting the input mode to AUTO the input will be automatically detected and you can then playback audio from the device you want by simply pressing an Input Selection button. Types of Input Signals Advice • It is possible to switch Input mode even if you press INPUT on CinemaStation for more than one second. • When Input mode is set to AUTO and a Dolby Digital or DTS signal is input, the most suitable decoder is automatically selected. • The following happens when set to Input mode and DTS is played: - CinemaStation detects the DTS signal and automatically switch to DTS mode (t indicator lights up). Once DTS audio finishes playback, the t indicator may blink, and while it blinks only DTS audio can be played back. Immediately after DTS audio finishes playback, if you want to play normal PCM audio, reset the Input mode to AUTO. - If the DTS signal is interrupted when you perform Search or Skip, the t indicator may blink. If this condition continues for over 30 seconds, the Input mode automatically changes from DTS to normal digital (PCM) and the t goes out. • Using "* Input Mode" in the SET MENU you can set whether to use the Input mode specified previously when CinemaStation was turned on or return to AUTO. Note • It is not possible to select ANLG with the DVD/CD Input Selection button. • You cannot switch input modes when the input jack you select with the Input Selection button can only input an analog input signal. • To play back DTS, set the Input mode to AUTO or DTS. Do not set it to ANLG. If you do, audio may not output or you may hear noise. 77 English