Yamaha P-200 Owner's Manual - Page 11

s UPPER PANEL- B ! VOLUME MAX MIN " #$ % & ( CS CONTRAST DATA ENTRY PS1 PS2 SPLIT TRANSPOSE MIDI -1/NO +1/YES BALANCE DETUNE PAGE ' ) C3 ! [VOLUME] slider This slider adjusts the overall volume of sound output from the internal speakers (or headphones, if connected) as well as the sound output from the [OUTPUT] jacks on the rear panel. Moving the slider upward increases volume level, while moving the slider downward decreases volume level. " [CS, DATA ENTRY] slider This is a multiple function slider. As a [CS] (continuous slider), you can assign it to control a variety of functions. As a [DATA ENTRY] slider, you can use it to change specific settings and parameters, depending on the current mode and status. Moving the slider upward increases the specified value, while moving the slider downward decreases the specified value. # [PS1, -1/NO] button This is a dual function button. As a [PS1] (Panel Switch 1) button, you can assign it to control various functions of the internal voices as well as connected MIDI devices, as set by the PS Edit function. As a [-1/NO] button, you can use it to change parameter settings in decrements. $ [PS2, +1/YES] button This is a dual function button. As a [PS2] (Panel Switch 2) button, you can assign it to control various functions of the internal voices as well as connected MIDI devices, as set by the PS Edit function. As a [+1/YES] button, you can use it to change parameter settings in increments. % [SPLIT, BALANCE, 1] button This is a multiple function button. As a [SPLIT] button, you can use it to enter Split mode, whether in Voice Play or Performance Play mode, determine the split point and assign the keyboard area for the main and sub voices. As a [BALANCE] button, you can use it to set the relative volume levels of each Split and Dual voice, by holding the [BALANCE] button and moving the [DATA ENTRY] slider ". As a [1] (cursor left) button in Edit mode, you can use it to move the cursor to the left in the LCD screen in order to position it over a desired parameter. & [TRANSPOSE, DETUNE, q] button This is a multiple function button. As a [TRANSPOSE] button, you can use it to set the keyboard transpose value for single as well as both Dual voices or Split voices. As a [DETUNE] button, you can use it to set the detune value for the two Dual voices, by holding it and moving the [DATA ENTRY] slider ". As a [q] (cursor right) button in Edit mode, you can use it to move the cursor to the right in the LCD screen in order to position it over a desired parameter. ' [MIDI, PAGE] button This is a dual function button. As a [MIDI] transmit button, you can use it to quickly enable or disable the P-200's transmission of MIDI messages. You can also hold the [MIDI] button while pressing other buttons to access certain features. As a [PAGE] button, you can use it to step through the various pages of Edit functions when the P-200 is in Edit mode. ( [CONTRAST] dial This dial lets you adjust the contrast of the LCD screen for optimum visibility. Rotating it to the left will decrease screen contrast, while rotating it to the right will increase screen contrast. ) LCD screen This backlit 32-character Liquid Crystal Display screen provides various information about the modes and operating status of the P-200. Certain messages are displayed only temporarily, but you can designate the "Popup Time" according to your preference. 11