Yamaha P-200 Owner's Manual - Page 56

INTERNAL CONTROL Off Reverb Depth Mod. Speed Total Volume Main Volume Sub Volume No function assigned Controls the reverb depth level Controls the modulation speed level Controls the P-200's overall volume Controls the main voice volume Controls the sub voice volume MIDI CONTROL CHANGE MESSAGES Modulation Breath Control Foot Control Porta. Time Data Entry Volume Balance Control Panpot Expression Sustain Portamento Sw Sostenuto Soft Pedal Legato Foot Hold 2 Harm. Content Release Time Attack Time Brightness Eff. 1 Depth Eff. 2 Depth Eff. 3 Depth Eff. 4 Depth Eff. 5 Depth Inc. Sw Dec. Sw NRPN LSB NRPN MSB RPN LSB RPN MSB Aftertouch 001 Sends a modulation message 002 Sends a breath control message 004 Sends a foot control message 005 Sends a portamento time message 006 Sends a data entry message 007 Sends a volume message 008 Sends a balance control message 010 Sends a stereo panning message 011 Sends a volume expression message 064 Sends a sustain message 065 Sends a portamento switch message 066 Sends a sostenuto message 067 Sends a soft pedal message 068 Sends a legato foot message 069 Sends a hold 2 message (such as "freezing" the operation of a synthesizer's envelope until the Footswitch is released) 071 Sends a harmonic content message 072 Sends a release time message 073 Sends an attack time message 074 Sends a brightness message 091 Sends an effect 1 depth message 092 Sends an effect 2 depth message 093 Sends an effect 3 depth message 094 Sends an effect 4 depth message 095 Sends an effect 5 depth message 096 Sends an increment switch message 097 Sends a decrement switch message 098 Sends a Non Registered Parameter number LSB bank select message 099 Sends a Non Registered Parameter number MSB bank select message 100 Sends a Registered Parameter Number LSB bank select message 101 Sends a Registered Parameter Number MSB bank select message Sends a channel aftertouch message q CONTINUOUS SLIDER ASSIGN (see chart) For assigning a specific function to the CS. (Default is main volume.) CS ASSIGN % main volume:007 q CONTINUOUS SLIDER RANGE MINIMUM (1~128) / MAXIMUM (1~128) The values set here determine the minimum and maximum volume range when you move the [CS] slider. (You cannot set the minimum number to exceed the maximum number.) CS RANGE MIN & 1#128 q FOOT CONTROLLER ASSIGN (see chart) For assigning a specific function to the foot controller (FC). (Default is sub volume.) FC ASSIGN ' total volume q FOOT CONTROLLER RANGE MINIMUM (1~128) / MAXIMUM (1~128) The values set here determine the minimum and maximum volume range when you press the [FC] controller. (You cannot set the minimum number to exceed the maximum number.) FC RANGE MIN ( 1#128 NOTE If you select Sys for CONTROL in the Performance Enable function (System menu), the controller assignment you have previously set for the currently selected Performance may actually be different, since the current setting (System setting) in the Voice Play mode will be active. You can change the System setting, and you can easily find which setting (Sys or Perf) is selected in the Performance Enable function, as the letter P will appear to the left of the page number if Perf is selected. NOTE The actual range (1 ~ 128) may actually be different depending on the selected function type. If the maximum range of the selected function is less than 128, the available range will be recognized and divided equally into 128 units, and the setting for Min/Max will be executed. 56