Yamaha PSR-530 Owner's Manual - Page 14

Setting Up, Power Supply, Using An Optional AC Power Adaptor, Using Batteries

Get Yamaha PSR-530 PDF manuals and user guides View all Yamaha PSR-530 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

,,QQ,,QQS,,QQett,,QQing,,QQUp,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ This section contains information about setting up your PSR-530 and preparing to play. Be sure to go through this section carefully before using your PSR-530. Power Supply Although the PSR-530 will run either from an optional AC adaptor or batteries, Yamaha recommends use of the more environmentally safe AC adaptor. Follow the instructions below according to the power source you intend to use. s Using An Optional AC Power Adaptor z Plug an optional Yamaha PA-6 Power Adaptor into a wall AC outlet. x Then plug the DC output cable from the PA-6 into the DC IN 10-12V jack on the rear panel of the PSR-530. The internal batteries are automatically disconnected when an AC Power Adaptor is used. DC IN 10-12V PA-6 When turning the power OFF, simply reverse the procedure. s Using Batteries For battery operation the PSR-530 requires six 1.5V SUM-1, "D" size, R-20 or equivalent batteries. When the batteries need to be replaced "LoBattry" may appear on top of the display, the volume may be reduced, the sound may be distorted, and other problems may occur. When this happens, turn the power off and replace the batteries. Replace the batteries as follows: z Open the battery compartment cover located on the instrument's bottom panel. x Insert the six new batteries, being careful to follow the polarity markings on the inside of the compartment. c Replace the compartment cover, making sure that it locks firmly in place. • Never interrupt the power supply (e.g. remove the batteries or unplug the AC adaptor) during any PSR-530 record operation! Doing so can result in a loss of data. • Use ONLY a Yamaha PA-6 AC Power Adaptor (or other adaptor specifically recommended by Yamaha) to power your instrument from the AC mains. The use of other adaptors may result in irreparable damage to both the adaptor and the PSR530. • Unplug the AC Power Adaptor when not using the PSR-530, or during electrical storms. • When the batteries run down, replace them with a complete set of six new batteries. NEVER mix old and new batteries. • Do not use different kinds of batteries (e.g. alkaline and manganese) at the same time. • If the instrument is not to be in use for a long time, remove the batteries from it, in order to prevent possible fluid leakage from the battery. • Plugging or unplugging the AC power adaptor while the batteries are installed will reset the PSR530 to the defaults. 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
12
Setting Up
This section contains information about setting up your PSR-530 and preparing to play. Be
sure to go through this section carefully before using your PSR-530.
Power Supply
Although the PSR-530 will run either from an optional AC adaptor or batteries,
Yamaha recommends use of the more environmentally safe AC adaptor. Follow
the instructions below according to the power source you intend to use.
■
Using An Optional AC Power Adaptor
z
Plug an optional Yamaha PA-6 Power Adaptor into a wall AC outlet.
x
Then plug the DC output cable from the PA-6 into the
DC IN 10-12V
jack on
the rear panel of the PSR-530. The internal batteries are automatically
disconnected when an AC Power Adaptor is used.
■
Using Batteries
For battery operation the PSR-530 requires six 1.5V SUM-1, “D” size, R-20 or
equivalent batteries.
When the batteries need to be replaced “LoBattry” may appear on top of the
display, the volume may be reduced, the sound may be distorted, and other
problems may occur. When this happens, turn the power off and replace the
batteries.
Replace the batteries as follows:
z
Open the battery compartment cover located on the instrument’s bottom panel.
x
Insert the six new batteries, being careful to follow the polarity markings on
the inside of the compartment.
c
Replace the compartment cover, making sure that it locks firmly in place.
DC IN 10-12V
PA-6
•
When the batteries run
down, replace them with a
complete set of six new
batteries. NEVER mix old
and new batteries.
•
Do not use different kinds
of batteries (e.g. alkaline
and manganese) at the
same time.
•
If the instrument is not to
be in use for a long time,
remove the batteries from
it, in order to prevent pos-
sible fluid leakage from
the battery.
•
Plugging or unplugging
the AC power adaptor
while the batteries are in-
stalled will reset the PSR-
530 to the defaults.
When turning the power OFF, simply reverse the procedure.
•
Use ONLY a Yamaha PA-6
AC Power Adaptor (or
other adaptor specifically
recommended by
Yamaha) to power your
instrument from the AC
mains. The use of other
adaptors may result in ir-
reparable damage to both
the adaptor and the PSR-
530.
•
Unplug the AC Power
Adaptor when not using
the PSR-530, or during
electrical storms.
•
Never interrupt the power
supply (e.g. remove the
batteries or unplug the
AC adaptor) during any
PSR-530 record opera-
tion! Doing so can result
in a loss of data.