Yamaha RX-V3900BL Owner's Manual - Page 141

After automatic setup Troubleshooting Warning message W1:Out of Phase W2:Over Distance W3:Level Error W4:SP Mismatch Cause Speaker polarity is not correct. This message may appear depending on the speakers even when the speakers are connected correctly. The distance between the speaker and the listening position is over 24 m (80 ft). The difference of volume level among speakers is excessive. The result of "Wiring" checked by the automatic setup is different from the settings manually configured in "Configuration". "Wiring" has not been checked. Remedy Check the speaker connections for proper polarity (+ or -). Bring the speaker closer to the listening position. Readjust the speaker installation so that all speakers are set in locations with similar conditions. Check the speaker connections. Use speakers of similar quality. Adjust the output volume of the subwoofer. Manually configure the speaker settings in "Configuration". Manually configure the speaker settings in "Configuration". See page 12 - - 12 - 30 87 87 Notes • If the "ERROR" or "WARNING" screens appears, check the cause of the problem, then run perform the automatic setup again. • If warning message "W2" or "W3" appears, the adjustments are made, however the adjustment may not be optimal. • Depending on the speakers, warning message "W1" may appears even if the speaker connections are correct. • If error message "E10" occurs repeatedly, contact a qualified Yamaha service center. ADDITIONAL INFORMATION English 137 En