Yamaha S03 Owner's Manual - Page 61
Rcv Ch MIDI Receive Channel, 1. NoteShift, 2. Detune, Mono/Poly, Part Mode, Rcv Ch, Detune
View all Yamaha S03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Multi Mode 6. Rcv Ch (MIDI Receive Channel) Set the MIDI Receive Channel for each Part. Each Part receives MIDI messages according to the channel set here. Select "off" for Parts that you do not want to respond to MIDI. Rcv Ch PAGE PART ELEM KEY 6 1 OCTAVE 01 ❏ Settings: 1 ~ 16, off n For information on setting the MIDI Receive channel in the Voice mode, see page 94. 7-1. NoteShift 7-2. Detune These parameters determine the pitch of each Part. NoteShift PAGE PART ELEM KEY 7 1 OCTAVE +00 Detune -12.0 PAGE PART ELEM KEY 7 1 OCTAVE I NoteShift Set the amount (in semitones) by which the note pitch is shifted. ❏ Settings: -24~0~+24 I Detune Determines the fine tuning setting of the pitch. Use this to create warm detuning effects by setting each Part to a slightly different value. ❏ Settings: -12.8 (Hz)~0~+12.7 (Hz) n Ignore the decimal place when inputting values from the numeric keypad. For example, to enter the value "-1.5," press the following buttons in order: "-," "1," then "5." 8. Mono/Poly Select monophonic or polyphonic playback. Select whether each Part is played back monophonically (single notes only) or polyphonically (multiple simultaneous notes). Mono/Poly PAGE PART ELEM KEY 8 1 OCTAVE poly ❏ Settings: mono, poly n When the Part Mode is set to "drum," "***" appears in the display and the parameter cannot be set. 9. Part Mode This determines whether the Part uses Normal Voices or Drum Voices. Part Mode PAGE PART ELEM KEY 9 1 OCTAVE norm ❏ Settings: norm (Normal Voice) With this setting, Normal Voices can be assigned to the Part. drum (Drum Voice) With this setting, Drum Voices can be assigned to the Part. drumS1/2 (Drum Setup 1/2) Used to play commercially available song data (switches automatically). n The part set to a setting other than "norm" is called a Drum Part. n If you've edited a drum kit in Drum Voice Edit mode and you wish to use that kit, set this to "drum." n When an XG System On message is received from an external sequencer, this is automatically set to "drumS1." In order to use the settigs made in Drum Voice Edit, record the appropriate message in the song data (Part Mode set to Drum). Refer to the MIDI Data Format section in the separate Data List. F0 43 10 4C 08 nn 07 01 F7 (nn=Part number) (hexadecimal) Part General 61