Yamaha SPX900 SPX900 Owners Manual Image - Page 6
Ctrl/foot - user manual
View all Yamaha SPX900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
00 • 0 0 POWER INPUT • CD SON/a OF 0 10 0 A 0,0 0 OE nYAM A rafF2Pan'PR0CESS0R LI LI EMORY 'DC 9 DC) SCROLL O O BACK PARAM LEVEL O O O 9 INT Er CTRL ECI PARAM ASSIGN A STORE -9 RECALL TRIG ER BYPASS FOOT 6 • Program Select and V'Keys These keys are used to select any of the SPX900's 6 memory locations. The key increments (increases) the memory location number while the 7 key decrements (decreases) the memory location number. Holding either key down causes continuous scrolling in the specified direction. • Details on page 6 • RECALL Key When a new memory location number has been selected 6 using the program select and Q keys, the RECALL key must be pressed to activate the selected effect. • Details on page 6 STORE Key This key is used to store edited effect programs into one of the user memory locations between 51 and 99. • Details on page 7 ® UTILITY Key This key accesses a set of utility functions allowing editing of effect titles, creation of original earlyreflection patterns, MIDI control programming, footswitch recall range programming and others. • Details on page 27 • TRIGGER Key The TRIGGER key allows manual triggering of any SPX900 effect program that has trigger parameters. The reverb programs, for example, include a triggerable gate, and the freeze programs allow triggering of recording and playback. The.TRIGGER key has the same function as a footswitch plugged into the rear-panel TRIGGER jack (THE CONNECTOR PANEL, 5). • BYPASS Key The BYPASS key switches the selected effect ON or OFF, leaving only the direct signal when BYPASS is active. The BYPASS key has the same function as a footswitch plugged into the rear-panel BYPASS jack (THE CONNECTOR PANEL, 3). • Details on page 6 4 LCD (Liquid Crystal Display) This 16-character x 2-line liquid crystal display panel normally displays the title of the selected effect on the top line and a selected parameter and its value on the bottom line. One or both lines may also be used to display error messages or warnings. """ will be displayed in the upper right corner while receiving the MIDI DATA. LED Memory Number Display This 2-digit numeric display shows the number of the currently selected memory location (1 - 99). When the LED display is continuously lit the effect corresponding to the number displayed is active. When the LED display is flashing, this indicates that a new memory location has been selected but has not yet been recalled, leaving the previously selected effect active. 41) Input Level Meter The input level meter consists of SEVEN LED segments, corresponding to -42 dB, -36 dB, -30 dB, -24 dB, -18 dB, -12 dB, and -6 dB input level. • EXT CTRL/FOOT VOL 1 and 2 Jacks Optional Yamaha FC7 Foot Controllers plugged into these jacks can be used to directly control SPX900 effect program parameters. The parameters to be controlled are assigned to the controllers using the EXT CTRL ASSIGN key (8). • Details on page 8