Yamaha THR30II THR30II Wireless THR10II Wireless THR10II Reference Manual - Page 5

Names and Functions !2 [ECHO /REV] knob Selects one of four different effects: ECHO (tape echo), ECHO/REV (tape echo/reverb), SPRING (spring reverb), and HALL (hall reverb). Turn the knob clockwise to increase the amount of each effect. * Turn the knob fully counterclockwise to set the effect OFF. * When ECHO or ECHO/REV is selected, the [TAP/TUNER] button e can be used to set the delay time. !3 [GUITAR] knob Adjusts the overall volume of the guitar sound. * This knob's setting has no effect on the signal sent to the [USB] jack @0. * The volume output to the [LINE OUT] [L] [R] jack (THR30II Wireless only) is constant regardless of the setting of the [GUITAR] knob. !4 [AUDIO] knob Adjusts the audio playback volume for audio from the computer connected to the [USB] jack @0, an audio device connected to the [AUX] jack !,7 or a smart device connected by Bluetooth (page 10). !5 [INPUT] jack This is a standard phone jack used to connect a guitar to the THR-II. * Connecting the Relay G10T to the [INPUT] jack starts charging that device automatically. (THR-II Wireless only) * The optimal channel is set automatically by connecting the Relay G10T to the [INPUT] jack for at least 10 seconds. (THR-II Wireless only) !6 [PHONES] jack This is a stereo mini phone jack used to connect stereo headphones to the THR-II. * Speaker sound is muted when a plug is inserted into the [PHONES] jack. !7 [AUX] jack This is a stereo mini phone jack used to connect an external audio device to the THR-II. * The signal received at the [AUX] jack is not sent to the [USB] jack @.0 !8 [USER MEMORY] [1] [2] [3] [4] [5] button Saves up to five sets of amp section controller settings (GAIN, MASTER, BASS, MIDDLE, TREBLE, EFFECT, ECHO/REV). Press and hold the number of the desired [USER MEMORY] button for saving your settings to (about 2 seconds). The save operation is complete when the memory number for the button being pushed appears in the LED Display w. Press one of the numbered buttons (less than 2 seconds) to recall the saved settings. * On the THR10II Wireless and THR10II, enable Bluetooth by pressing the [USER MEMORY] button [4] and [5] simultaneously.(Same as [Bluetooth] button !)9 !9 [Bluetooth]button (THR30II Wireless only) Set the Bluetooth. Press and hold for three seconds to activate Bluetooth pairing. The LED display w will flash in green. For further details, refer to the section "Connecting to a smart device" on page 10. THR30II Wireless THR10II Wireless THR10II Reference Manual 5