Yamaha THR30II THR30II Wireless THR10II Wireless THR10II Reference Manual - Page 9

Connection  Charging the built-in battery (THR-II Wireless only) Connect the supplied power adaptor to the DC IN jack located on the rear side of the THR-II Wireless. The LED of the power button lights in green while charging. * For further details of the Power Button LED state, refer to the THR30II Wireless, THR10II Wireless* Power Button LED status list (page 17). NOTICE • When you use the THR-II Wireless in an environment of extreme temperatures, charging may not be possible. • Charge the built-in rechargeable battery once every six months to maintain the function.  Charging the Relay G10T (THR-II Wireless only) Connect the Relay G10T *1 to the [INPUT] jack located on the top of the THR-II Wireless. The built‐in rechargeable battery starts *2 charging automatically. If you have disconnected the Relay G10T from the [GUITAR] jack of the THR-II Wireless and want to resume charging, wait for more than two seconds before reconnecting the device to the [GUITAR] jack. *1 Refer to the manual of Relay G10T for explanations of LED display indications on the Relay G10T. *2 If the supplied power adapter is not connected to the THR-II Wireless, charging of the Relay G10T will not start. NOTICE • After charging, unplug the Relay G10T from the THR-II Wireless. • When the THR-II Wireless is turned off and the power adapter is connected, the Relay G10T is charged by simply connecting. However, the THR-II Wireless is set to stop supplying power to the Relay G10T when the Relay G10T charging is finished. In this state, leaving the Relay G10T connected to the THR-II Wireless may result in depletion of the Relay G10T's battery power. Turn off the THR-II Wireless's ECO setting to prevent this.  Changing the Relay G10T's ECO setting *1 *2 1. Switch on the power of THR-II Wireless 2. Switch off the power of THR-II Wireless while holding the [TAP/TUNER] button *3 Switch off the power while holding the [TAP/TUNER] button. *1 You can change the ECO setting from the THR Remote. *2 ECO on and ECO off are toggle. When you change the ECO setting, perform the steps 1 to 2 again. *3 Since the ECO setting changes to ECO off when charging is started on the Relay G10T, "C" will appear on the LED display. Connecting to guitar by wireless (THR-II Wireless only) The THR-II Wireless can connect with the Relay G10T wireless guitar transmitter (made by Line 6) by wireless. Moreover, the optimal channel is set automatically by connecting the Relay G10T to the [INPUT] jack located on the top of the THR-II Wireless for at least 10 seconds. For details on wireless connection, refer to the Relay G10T's manual. THR30II Wireless THR10II Wireless THR10II Reference Manual 9