Yamaha YSP-1600 Owners Manual - Page 21
Setting the HDMI control function, Changing the connection method and, connected devices
View all Yamaha YSP-1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
123456 Setting the HDMI control function 1 Turn on the unit, TV, and playback devices. 2 Activate the HDMI control function on the unit, TV, and playback devices such as BD/DVD players that support this function. For this unit, be sure that "HDMI Control" is set to "On" (default; p. 51). For playback devices, refer to the instructions supplied with HDMI each device. If devices are not coordinated Be sure that all devices are correctly connected to this unit, and that settings are properly configured as described below. - "HDMI Control" (p. 51) is set to "On" in the setup menu. - The HDMI control function is enabled on the TV. The example of TV settings • From the setup menu on your TV, select "Link setting" "HDMI control setting", then set a setting such as "HDMI control function" to "ON". • Set audio output to any option other than TV. 3 Turn off the main power of the TV and then turn off the unit and playback devices. 4 Turn on the unit and playback devices and then turn on the TV. 5 Switch the TV input to display the video from the unit. If devices fail to coordinate even after the settings described above have been applied correctly: - Turn off this unit and the TV, and then turn them back on again. - Disconnect the power cable of the unit and external devices connected to the unit via HDMI cable. Plug them in again after about 30 seconds. - If devices fail to coordinate after ANALOG is input, repeat steps 5 and 6 under "Setting the HDMI control function". 6 Press the HDMI key to select HDMI input, and check that video from the playback device is properly displayed. HDMI Glows (green) 7 Check that the unit is properly coordinated with the TV by turning off the TV or adjusting the TV volume with the TV remote control. Changing the connection method and connected devices When the connected devices and jacks are changed, configure the settings again with the following procedure. 1 Disable the HDMI control function of the TV and BD/ DVD player, turn off all connected devices, and change the connections. 2 Follow steps 1 to 7 of "Setting the HDMI control function". PREPARATIONS ➤ f Initial settings En 21