Yamaha YV-1600A Owner's Manual - Page 25

ASSEMBLY : YV-2700/2700G/1600A/520 8 Connect the slide legs with the legs. Align the legs from above so that the slide legs slide into the corresponding leg holes. Adjust to the desired height and then securely tighten each slide leg fixing bolt, aligning it with the corresponding notch of the slide leg. Fixing bolt and notch are aligned when the next lower notch is flush with the upper leg flange. Align notch with upper flange. Do not touch the notched part during height adjustment to avoid injury. * The fourth notch from the tone bar side corresponds to the standard height setting. High Sound Side Low Sound Side When a slide leg fixing bolt is tightened in between two notches, there is a danger of the slide leg slipping. Always make sure that the slide legs are held securely. 9 After fixing the legs, connect the pedal with the sustain damper. q For YV-2700/2700G: z Loosen the center rod fixing bolts to extend the center rod. x Connect the center rod with the fitting of the rod connector by firmly holding the center rod while turning the rod connector. c Tighten the rod connector until it stops, and then secure with the lock nut. z Loosen Center Rod Fixing Bolt Rod Connector x Turn (screw on) Lock Nut c Secure Center Rod Knurled Part z Loosen Pedal Rod 23