ZyXEL Omni 288S User Guide - Page 113

Chapter 12 - Status Registers & Result Codes Command bit 1 S41= bit 0 2 3 4 5 6 7 S42= bit 3 4 5 6 7 S43= bit 0 dec 2 dec 1 4 8 16 32 64 128 dec 8 16 32 64 128 dec 1 hex 2 hex 1 4 8 10 20 40 80 hex 8 10 20 40 80 hex 1 Function and description Ref. No result code displayed in answer mode Q2 Bit mapped register +000 Special MNP compatibility (see also S27.0, &Kn S38.5) Disable retrain abort, up to 5 min. for special S27.6 satellite line condition *n Enable CCITT signals 140 and 141 on EIA- 232D interface In X2-X7 setting, modem waits for S6 seconds before dialing and ignores dial tone detection DSR follows DCD and pulses (see also &Sn S44.4) Force S0>=2 S0 Ignore calling tone, not to be used as fax detection Bit mapped register +000 Disable escape sequence code in answer mode Disable V.17, 14,400 Fax in calling mode, no effect to answering mode &N32 Disable Data/Voice button Disable 'RINGING' result code Xn DCD forced on but pulse off for 0.5 seconds &C0 at carrier loss Bit mapped register +000 Disable ZyXEL 16800 in Multi-Auto mode &N0 1 2 2 Disable ZyXEL 19200 in Multi-Auto mode &N0 2 4 4 Disable cellular mode automatic transmit &N0 power adjustment (see also S49b0-3) 3 0 0 Enable cellular mode in Multi-Auto mode. &N0 8 8 Disable cellular mode in Multi-Auto &N0 6 64 40 Enable 1.5 sec, pause between off-hook and modem answering 7 128 80 Modem hang-up if the line condition does not permit modem to run highest speed set by '&Nn' command S44= bit dec hex Bit mapped register +000 3 8 8 ATDSn initiates auto-dial of the stored DSn numbers consecutively until connection is made 4 16 10 DSR follows DTR (see also S41.5) &S1 5 32 20 Enable V.13 half-duplex simulation in synchronous mode 12-7