ZyXEL Omni 288S User Guide - Page 24
Setup for DOS Fax/Modem Software
View all ZyXEL Omni 288S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Chapter 2 - Installation If the User name and Password are incorrect or missing, type them in. Click on the Connect button and your Omni 288S will dial the number and establish a connection to your Internet Service Provider. Note: The default protocol for Dial-up Networking is Point-to-Point Protocol (PPP). If your ISP requires you to use Serial Line Interface Protocol (SLIP), you may need to create a special logon script file. Because the procedures for logging on with SLIP accounts vary greatly from ISP to ISP, you should consult the technical support department of your service provider for this information. Setup for DOS Fax/Modem Software After installing the Omni 288S, use the following procedures to verify your modem connections. 1. Install and load your communications software. If you need assistance, refer to the manual that came with the software. 2. If your communications software requires you to select a modem, and the ZyXEL Omni 288S is not one of the choices, you can either check our web site for the driver or select the ZyXEL U-1496 modem. In many cases, the commands for these modems are identical. 2-9