ZyXEL P-964 User Guide - Page 17

P964 APR Cable Router with 802.11g Access Point Chapter 2 Hardware Installation and Initial Setup This chapter shows the procedures for installing and starting the P964 APR. 2.1 Front Panel LEDs and Back Panel Ports The P964 APR provides LEDs as status indicator for diagnostics purpose. The following figure and table describe the functions of LEDs on the front panel of P964 APR : Figure 2-1 P964 APR front panel Table 2-1 P964 APR LED Functions FUNCTION NAMING COLOR LED DESCRIPTION Power PWR Green On: Power On Off: Power Off System SYS Green or Orange On (Green): System ready and running successfully On (Orange): System is loading the configuration On (Green): System rebooting Off: System not ready LAN link/activity LAN 1~4 Green (10M) or Orange (100M) On: LAN 1~4 Ethernet port link successful Flashing: LAN 1~4 is Sending or Receiving Off: LAN 1~4 Ethernet port not ready USB USB Green On: USB link successful Flashing: Sending or Receiving Off: USB not ready WLAN WLAN Green On: WLAN link successful Flashing: Sending or Receiving Off: WLAN not ready Cable data DATA activity Green Flashing: WAN port (Cable Interface) TX/RX Off: Connection is idle Cable link CABLE Green status On: The P964 APR is registered successfully with Cable Modem Terminal System (CMTS) Slow Flash (2 seconds interval): The P964 APR is scanning downstream channel Fast Flash (1 second interval): The P964 APR is locked on to downstream channel and is ranging and registering with CMTS The SYS LED is always GREEN while system is ready or rebooting. The SYS LED will become ORANGE when the system is loading its configuration. Don't power off or reset your P964 APR during the SYS LED is ORANGE. You can only power off or reset your P964 APR after the SYS LED returns GREEN. Otherwise, your P964 APR will not work properly anymore. Hardware Installation 2-1