ZyXEL SBG3300-N000 User Guide - Page 279
Add/Edit VPN Rule
View all ZyXEL SBG3300-N000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 279 highlights
Chapter 20 IPSec VPN Click VPN > IPSec VPN to display the Setup screen. This is a read-only menu of your IPSec VPN rules (tunnels). Edit a VPN rule by clicking the Edit icon. Note: The default IPsec rule Default_L2TPVPN cannot be disconnected on the VPN > IPSec VPN > Monitor screen. However, you may disconnect L2TP tunnels in the VPN > L2TP > Monitor screen. Figure 118 VPN > IPSec VPN > Setup The following table describes the fields in this screen. Table 89 VPN > IPSec VPN > Setup LABEL Add New Entry # Enable DESCRIPTION Click this button to set up VPN policies for a new tunnel. This is the VPN policy index number. This field displays whether the VPN policy is active or not. Name Remote Gateway Address Local Gateway Address Remote Policy Local Policy Modify This icon is turned on when the rule is enabled. This field displays the identification name for this VPN policy. This field displays the Secure Gateway Address of the IPSec router with which you're making the VPN connection. This field displays the IP address used by the Device. If the selected interface is not available, this field will display 0.0.0.0. This field displays the remote policy. This field displays the local policy. Click the Edit icon to go to the screen where you can edit the VPN rule. Click the Remove icon to remove an existing VPN rule. 20.4.1 Add/Edit VPN Rule You can click the Add New Entry button or a policy's Edit icon in the IPSec VPN > Setup screen to either add or edit a VPN policy. Note: The Device uses the system default gateway interface's WAN IP address as its WAN IP address to set up a VPN tunnel. SBG3300-N Series User's Guide 279