ZyXEL SBG3300-N000 User Guide - Page 353
OAM Ping Test
View all ZyXEL SBG3300-N000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 353 highlights
Chapter 38 Diagnostic 38.5 OAM Ping Test Click Maintenance > Diagnostic > OAM Ping Test to open the screen shown next. Use this screen to perform an OAM (Operation, Administration and Maintenance) F4 or F5 loopback test on a PVC. The Device sends an OAM F4 or F5 packet to the DSLAM or ATM switch and then returns it to the Device. The test result then displays in the text box. ATM sets up virtual circuits over which end systems communicate. The terminology for virtual circuits is as follows: • Virtual Channel (VC) • Virtual Path (VP) • Virtual Circuits Logical connections between ATM devices A bundle of virtual channels A series of virtual paths between circuit end points Figure 163 Virtual Circuit Topology Think of a virtual path as a cable that contains a bundle of wires. The cable connects two points and wires within the cable provide individual circuits between the two points. In an ATM cell header, a VPI (Virtual Path Identifier) identifies a link formed by a virtual path; a VCI (Virtual Channel Identifier) identifies a channel within a virtual path. A series of virtual paths make up a virtual circuit. F4 cells operate at the virtual path (VP) level, while F5 cells operate at the virtual channel (VC) level. F4 cells use the same VPI as the user data cells on VP connections, but use different predefined VCI values. F5 cells use the same VPI and VCI as the user data cells on the VC connections, and are distinguished from data cells by a predefinded Payload Type Identifier (PTI) in the cell header. Both F4 flows and F5 flows are bidirectional and have two types. • segment F4 flows (VCI=3) • end-to-end F4 flows (VCI=4) • segment F5 flows (PTI=100) • end-to-end F5 flows (PTI=101) OAM F4 or F5 tests are used to check virtual path or virtual channel availability between two DSL devices. Segment flows are terminated at the connecting point which terminates a VP or VC segment. End-to-end flows are terminated at the end point of a VP or VC connection, where an ATM link is terminated. Segment loopback tests allow you to verify integrity of a PVC to the nearest neighboring ATM device. End-to-end loopback tests allow you to verify integrity of an end-to-end PVC. Note: The DSLAM to which the Device is connected must also support ATM F4 and/or F5 to use this test. SBG3300-N Series User's Guide 353