ZyXEL WAP6804 User Guide - Page 28
Access Point Mode, 5.1 Overview, 5.1.1 What You Can Do, 5.2 Setting your WAP6804 to AP Mode
View all ZyXEL WAP6804 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
CHAPTER 5 Access Point Mode 5.1 Overview The WAP6804 is set to access point mode by default. In this mode your WAP6804 (AP) bridges a wired network (LAN) and wireless LAN (WLAN) in the same subnet. See the figure below for an example. Figure 11 Access Point Mode 5.1.1 What You Can Do • Use the Status screen (Section 5.2.1 on page 29) to view read-only information about your WAP6804. • Use the Network > Networking screen (Chapter 10 on page 57) to set the IP address for your WAP6804 acting as an access point. • Use the Wireless Network 5G/2.4G screens (Chapter 11 on page 60) to configure the wireless settings and wireless security between the wireless clients and the WAP6804. 5.2 Setting your WAP6804 to AP Mode 1 To use your WAP6804 as an access point, see Section 3.1.3 on page 23. 2 Connect your computer to the LAN port of the WAP6804. 3 The default static LAN IP address of the WAP6804 in AP mode is 192.168.1.2. The WAP6804 cannot assign your computer an IP address, so you must give it a fixed IP address in the range between 192.168.1.3 and 192.168.1.254 (Section 2.3 on page 16) if the WAP6804 is not connected to a router or DHCP server. 4 After you've set your computer's IP address, open a web browser such as Internet Explorer and type "http://zyxelsetup" (for Windows), http://zyxelsetup.local" (for Mac), "http://(DHCP-assigned IP), or "http://192.168.1.2" as the web address in your web browser. WAP6804 User's Guide 28