1997 Chevrolet Blazer Owner's Manual - Page 292
1997 Chevrolet Blazer Manual
Page 292 highlights
Taillamps 1. Open the endgate. 6. Push the new bulb straight into the socket until it clicks. 2. Remove the two screws from the lamp assembly. 7. Put the socket into the lamp assembly and turn the socket clockwise until it locks into place. 8. Install the lamp assembly and screws. 9. Close the endgate. Underhood Lamp 1. Disconnect the electrical connector from the underhood lamp assembly. 2. Remove the screws. 3. Disconnect the ground wire. 4. Remove the lamp assembly from the hood. 3. Pull the assembly away from the vehicle. 5 . Install the new bulb. 4. Turn the socket counterclockwise to remove it. Push the tab in while you turn the socket counterclockwise. 5. Holding the base of the bulb, pull the bulb straight out of the socket. 6. Replace the assembly. Install and tighten the screws. 7 . Connect the ground wire. 8. Connect the electrical connectorto the lamp assembly.