2003 Chevrolet Monte Carlo Owner's Manual - Page 113
2003 Chevrolet Monte Carlo Manual
Page 113 highlights
If your vehicle has the optional content theft-deterrent system, the first time a remote UNLOCK command is received, three flashes will be seen and three horn chirps heard to indicate an alarm condition has occurred since last arming. See Content Theft-Deterrent on page 2- 15. The mode you selected is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle. 2. Press the 1 PREV or 2 NEXT button to enter the submenu. The current selection will have an asterisk (*) next to it. If you do not wish to change the current mode, you can either exit the programming mode by following the directions later in this section or program the next feature available on your vehicle. 3. Scroll, using the 1 PREV or 2 NEXT buttons, through the modes to change the current mode. ALARM (Content Theft Operation) This feature allows the content theft-deterrent system to be turned on or off. 4. With your preference displayed, press the TUNE DlSP button to select. A chime will be heard to verify the new setting. The new selection will be displayed with an asterisk (*) for one second. The mode you selected is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle. Programmable Modes Mode 1: ALRM OFF - Turns feature oft. Mode 2 ALRM ON - Turns feature on. : Before your vehicle was shipped from the factory, it was programmed to Mode 2. The mode to which your vehicle was programmed may have been changed since it left the factory. To determine the mode to which your vehicle is programmed or to program your vehicle to a different mode, do the following: TRNKJAMB (Trunk Jamb) This feature allows the content theft system trunk lock sensor to be disabled or enabled. Programmable Modes Mode 1: TRNK OFF - Turns feature off. 1. Scroll, using the SEEK PSCAN up or down arrows, until ALARM appears on the display. : Mode 2 TRNK ON - Turns feature on. 2-48