2009 Chevrolet Corvette Owner's Manual - Page 146

Turn and Lane-Change Signals (Auto Signal) An arrow on the instrument panel cluster flashes in the direction of the turn or lane change. Turn Signal on Chime A chime sounds if the turn signal has been on for more than three-quarters of a mile (1.2 km) of driving. If you need to leave the turn signal on for more than three-quarters of a mile (1.2 km), turn off the signal and then turn it back on. Headlamp High/Low-Beam Changer To change the headlamps from low beam to high, push the turn signal lever all the way forward. To change from high to low beam, pull the lever rearward. While the high beams are on, this light on the instrument panel cluster will also be lit. Move the lever all the way up or down to signal a turn. Raise or lower the lever until the arrow starts to flash to signal a lane change. Release the lever and the turn signal automatically flashes three times. If more flashes are desired, continue to hold the lever. The lever returns to its starting position when it is released. If after signaling a turn or lane change the arrows flash rapidly or do not come on, a signal bulb may be burned out. Have the bulbs replaced. If the bulb is not burned out, check the fuse. See Fuses and Circuit Breakers on page 5-103. Flash-to-Pass To use the flash-to-pass feature, briefly pull the turn signal lever toward you. The high-beam indicator flashes to indicate to the other driver that you intend to pass. If the low-beam headlamps are off and the fog lamps are on, the fog lamps flash. 3-8