2009 Chevrolet Corvette Owner's Manual - Page 263
2009 Chevrolet Corvette Manual
Page 263 highlights
ZR1 Brake Burnish Procedure Notice: These procedures are specific to the ZR1 with ceramic brake rotors. These procedures should not be run on other Corvette models as damage may result. Notice: The new vehicle break-in period should be completed before performing the brake burnish procedure or damage may occur to the powertrain/engine. See New Vehicle Break-In on page 2-21. When performed as instructed, these procedures will not damage the brakes. During the burnishing procedure, the brake pads will smoke and produce an odor. The braking force and pedal travel may increase. After the procedure is complete, the brake pads may appear white at the rotor contact. Street High Performance Brake Burnishing Procedure Run this procedure in a safe manner and in compliance with all local and state ordinances/laws regarding motor vehicle operation. Run this procedure only on dry pavement. 1. From a stop, accelerate as rapidly as possible without activating traction control to a speed of 60 mph (97 kph). 2. Use enough pedal force to completely stop the vehicle in 4 to 5 seconds. If ABS activates, braking is too hard. 3. Repeat steps 1 and 2, 50 times. This should take about 10 minutes. 4. After completing the 50 stops, cool the brakes by driving for 5 miles (8 km) at 60 mph (97 kph). As with all high performance brake systems, some amount of brake squeal is normal. 4-15