2009 Chevrolet Corvette Owner's Manual - Page 150

Resuming a Set Speed If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged. But it does not need to be reset. Once the vehicle is going about 25 mph (40 km/h) or more, you can move the cruise control switch briefly from R to S . The vehicles goes back up to your chosen speed and stays there. If the switch is held at resume/accelerate the vehicle keeps going faster until the switch is released or the brake is applied. Do not hold the switch at resume/ accelerate, unless you want the vehicle to go faster. Increasing Speed While Using Cruise Control There are two ways to go to a higher speed: • Use the accelerator pedal to get to the higher speed. Press J at the end of the lever, then release the button and the accelerator pedal. The vehicle now cruises at the higher speed. If the accelerator pedal is held longer than 60 seconds, cruise control will turn off. • Move the cruise switch from R to S . Hold it there until desired speed is reached, and then release the switch. To increase the vehicle speed in small amounts, move the switch briefly to S . Each time this is done, the vehicle goes about 1 mph (1.6 km/h) faster. Reducing Speed While Using Cruise Control • Press and hold the set button until the lower speed desired is reached, then release it. • To slow down in small amounts, briefly press J . Each time this is done, the vehicle goes about 1 mph (1.6 km/h) slower. 3-12