2010 Chevrolet Suburban 2500 Owner's Manual - Page 11

Starting the Vehicle 1. Aim the RKE transmitter at the vehicle. 2. Press Door Locks There are several ways to lock and unlock the vehicle. From outside, use the Remote Keyless Entry (RKE) transmitter or the key in the driver door. From inside, use the power door locks or the manual door locks. To lock or unlock the door with the manual locks, push down or pull up on the manual lock knob. Q. 3. Immediately after completing Step 2, press and hold / until the turn signal lamps flash. When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on. The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once. Power Door Locks If available, these switches are located on the front doors. K : Press to unlock the doors. Q : Remove the key from the ignition and press to lock the doors. For more information, see: . Canceling a Remote Start To cancel a remote start: . Aim the RKE transmitter at the vehicle and press and hold / until the parking lamps turn off. Turn on the hazard warning flashers. Turn the ignition on and then back off. Programmable Automatic Door Locks on page 3‑11. Rear Door Security Locks on page 3‑11. . . . See Remote Vehicle Start on page 3‑8. 1-5